How to Change your Roller Foot to a Regular Presser Foot
For Techsew 810 Industrial Sewing Machine
Section 1 - Removing the Roller Foot
1- Push downwards on the roller foot and swing it to the left. While holding the spring and retaining pin in place, remove the 2 lower presser foot holder screws. |
 |
 |
| 2-Remove the lower presser foot holder, spring and retaining pin. |  |
 |
| 3. Remove the upper roller presser foot holder. | 
|
 |
Section 2 - Install the Presser Foot
| 1. Slide the new presser foot holder up to its highest position onto the presser foot bar. Next, tighten the 2 screws with a hex key. |  |
 |
| 2. Insert the new presser foot (parallel to the feedog) to its highest position, and secure it by tightening the presser foot screw on the left side with a screwdriver. |  |
 |
3. With a screwdriver, loosen the presser foot bar screw which is located on the left side of the sewing machine. Pull the presser foot bar downwards until the presser foot makes contact with the feed dog. Make sure the hole in the presser foot aligns with the hole in the needle plate. |
 |
 |
4. Make sure the needle lowers down directly into the center of the hole in the presser foot. Finally, tighten the presser foot bar screw on the left side of the machine. |
 |
|
|
 |
Techsew 810 Presser Foot Set
- zipper foot (for sewing zippers or sewing along the edge of material)
- teflon foot (for sticky materials such as vinyl, leather)
- wide hinge foot (for bulky materials)
Click HERE to purchase
info@raphaelsewing.com
www.raphaelsewing.com
1-866-415-8223
Raphael Sewing
Machines
8440 St Laurent Blvd. Suite 200
Montreal, Quebec,
Canada H2P2M5
1-866-415-8223